TAP Services

1. Electrical licensing requirements are set by ________.

NCCER

states or municipalities

DOL

OSHA

Question 1 of 15

2. To install a raceway system with little or no waste in RMC, an electrician must be skilled in ________.

installing motor controllers

troubleshooting

conduit bending

assembling luminaires

Question 2 of 15

3. Industrial electricians are generally split into two groups: maintenance personnel and _____.

supervisors

installers

instrumentation specialists

contractors

Question 3 of 15

4. Which of the following should be done if an unsafe condition is observed on a job site?

It should be reported to the supervisor.

Employees should stay at the site and divert other people away.

OSHA should be notified.

A letter should be written to the owner.

Question 4 of 15

5. Electrical contractors typically employ ________.

commercial electricians

industrial electricians

E&I technicians

maintenance electricians

Question 5 of 15

6. Electricians who are responsible for their own taxes and providing their own insurance are considered ________.

individual contractors

commercial electricians

apprentices

E&I technicians

Question 6 of 15

7. Before awarding a journeyman certificate, a typical electrical apprenticeship program requires 144 hours per year of ________.

safety training

on-the-job learning

off-site training

classroom instruction

Question 7 of 15

8. Installing nail-on device boxes, panelboards, and lighting fixtures in new houses are tasks performed by ________.

residential electricians

industrial electricians

electrical maintenance technicians

commercial electricians

Question 8 of 15

9. Before awarding a journeyman certificate, a typical electrical apprenticeship program requires 8,000 total hours of ________.

off-site training

safety training

classroom instruction

on-the-job learning

Question 9 of 15

10. Once you have been given an assignment and all the procedures and safety guidelines are fully understood, you should ________.

wait until the area supervisor gives the okay to start

wait 24 hours before starting on the project

assume responsibility for the task without further reminders

find a co-worker to help with the project

Question 10 of 15

11. Which of the following describes the standard in NFPA 70E®?

Safe work practices must be applied when working on or near exposed energized parts.

All tools, equipment, and machines must be inspected by the employer before use.

Employers with more than ten employees must keep records of work-related injuries and illnesses.

A worker with a disability has equal rights to employment.

Question 11 of 15

12. An electrician who must know how to disassemble and reassemble magnetic motor starters is a(n) ________.

industrial maintenance electrician

residential electrician

commercial electrician

industrial electrician

Question 12 of 15

13. Why must an arcing device be contained within a special enclosure?

To lock out any unauthorized users of the device

To allow gases and vapors to enter the conduit system

To prevent the ignition of hazardous vapors

To keep out dust and protect the device

Question 13 of 15

14. Before a trainee can advance to the next stage of the curriculum, they must demonstrate knowledge of the hands-on tasks learned in each module. This is referred to as ________.

on-the-job learning

an apprenticeship program

a competency-based program

standardized testing

Question 14 of 15

15. Electricians that work with three-phase power, motors, and motor control systems most likely work in ________.

residential construction

office buildings

apartment buildings

industrial facilities

Question 15 of 15

Mailing List

Quick Nav

TAP Services

	FOLLOW US ON SOCIAL MEDIA

TAP Services

Mailing List

Quick Nav

Get Social

TAP Services