TAP Services

1. Which of the following counts as two conductors when used in a box?

Each looped conductor over 12"

Each fixture stud

Each cable clamp

Each looped conductor over 6"

Question 1 of 15

2. If a switch is used in a box where no grounding conductors are part of the wiring, how many conductors must be deducted?

Question 2 of 15

3. The NEC® requires that all octagon boxes have a minimum depth of ________.

1-1/2"

1-1/4"

1/2"

1/4"

Question 3 of 15

4. Which of the following is a general NEC® requirement for installing boxes?

The box must be of a sufficient size to permit locknuts to be properly installed.

The box must be at least 2" deep.

The finished installation must be accessible for future repair or maintenance.

The box must be installed flush to the wall surface.

Question 4 of 15

5. Which of the following pulls requires the length of the box to be no less than eight times the trade diameter of the largest raceway?

Circle pull

Angle pull

Straight pull

U pull

Question 5 of 15

6. A handy box is a special single-gang box that is also known as a ________.

round box

masonry box

square box

utility box

Question 6 of 15

7. What is the minimum length on a straight pull for a pull box with two 1" conduits and one 5" conduit on one wall, and two 1" conduits and one 5" conduit entering the opposite wall?

64"

40"

48"

56"

Question 7 of 15

8. How many additional conductors (wires. must be deducted from a box that contains a maximum number of eight No. 12 wires and two spliced conductors?

Question 8 of 15

9. According to NEC Section 210.52 , laundry areas require at least ________.

three receptacles

four receptacles

two receptacles

one receptacle

Question 9 of 15

10. The special box used in a flat-slab construction job is known as a ________.

metallic octagon box

nonmetallic device box with integral nails

nonmetallic device box with side bracket

masonry box

Question 10 of 15

11. Which type of boxes are typically used for wall-mounted lighting fixtures?

Aluminum boxes with threaded hubs

Octagon and round boxes

Handy boxes

NM device boxes

Question 11 of 15

12. Which of the following will cause the number of conductors allowed in a box to be reduced?

The addition of box extension rings

The shape of the box

The use of cable clamps

Locating the box in a wet area

Question 12 of 15

13. According to NEC Section 210.52(C.(5. , the maximum mounting height for a receptacle installed above a kitchen countertop is ________.

20"

14"

Question 13 of 15

14. What size of a junction box must be used if there is one 4" conduit and two 3" conduits entering on one side of the box and exiting at a 90° angle on another side of the box? (asume the conductor size is No. 4 AWG or larger).

30"

56"

60"

48"

Question 14 of 15

15. Two cables that each have two wires enter a box, are connected to a terminal, and then exit again. The total conductor count is ________.

Question 15 of 15

Mailing List

Quick Nav

TAP Services

	FOLLOW US ON SOCIAL MEDIA

TAP Services

Mailing List

Quick Nav

Get Social

TAP Services