1. In residential applications, black iron pipe is used _____.

2. The acronym MPT associated with a fitting means that a _____.

3. In the thread specification 3/4 – 14 NPT, 3/4 represents _____.

4. Which of the following situations requires a tee fitting?

5. The method used to measure a pipe with a fitting on one end is _____.

6.
Which type of pipe measurement is shown in the figure above?

7. A typical tapered pipe reamer can usually handle pipe sizes as large as _____.

8. In order to hold a 4″ pipe for cutting, you would need a _____.

9. Which of the following is a correct statement regarding pipe threading?

10. Pipe dope is used to _____.

11. When joining grooved pipe, which step is performed immediately after the housing is installed?

12. When installing grooved pipe couplings, the coupling housing halves are tightened together until _____.

13. Which of the following grooving methods does not remove any material from the pipe?

14. When tightening flange bolts, you should use a _____.

15. Vertical pipe runs should be supported at each floor level using _____.